passive-interface
To suppress routing updates on an interface, use the passive-interface command. To revert to the default settings, use the no form of this command.
passive-interface default
no passive-interface default
Syntax Description
default |
Specifies interfaces that are passive by default. |
Command Default
None
Command Modes
Router configuration
Command History
Release |
Modification |
---|---|
5.2(1) |
This command was introduced. |
Usage Guidelines
This command does not require a license.
Examples
This example shows how to suppress routing updates on the interface:
switch# configure terminal
switch(config)# interface ethernet 5/4
switch(config-if)# router ospf 2
switch(config-router)# passive-interface default
switch(config-router)#
This example shows how to remove the configuration for the routing updates suppression:
switch# configure terminal
switch(config)# interface ethernet 5/4
switch(config-if)# router ospf 2
switch(config-router)# no passive-interface default