The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
To assign a VLAN to a configured VLAN group, use the vlan command. To remove the VLAN from the VLAN group, use the no form of this command.
verify vlan-range
vlan-range |
Specifies the VLAN range. The range is from 1 to 3967. |
None.
VLAN group configuration mode (config-vlan-group)
Release |
Modification |
---|---|
Cisco NX-OS 8.0(1) |
This command was introduced. |
Catena must be enabled and configured before using this command. For more information about these task, see "Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution."
The following example shows how to assign a VLAN to a VLAN group:
switch# configure terminal switch(config)# catena vlan-group vg1 switch(config-vlan-group)# vlan 10 switch(config-vlan-group)# vlan 20-30 switch(config-vlan-group)# vlan 40,50
Command |
Description |
---|---|
Creates a VLAN group. |