L Commands

load-balance port-channel

To load balance the traffic in a port channel in a port group, use the load-balance port-channel command. To remove the load-balance, use the no form of this command.

load-balance port-channel

no load-balance port-channel

Syntax Description

load-balance

Specifies the Catena load-balance.

port-channel

Specifies the port channel of all interfaces in a port group.

Command Default

The traffic is not load balanced by default.

Command Modes

Port group configuration (config-port-group)

Command History

Release

Modification

Cisco NX-OS 8.2(1)

This command was introduced.

Usage Guidelines

Catena must be enabled and configured before using this command. For more information about these task, see "Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution."

Examples

The following example shows how to load-balance a port channel in a port group: 

switch# configure terminal
switch(config)# catena port-group pg1
switch(config-port-group)# load-balance port-channel

Related Commands

Command

Description

catena device-group

Creates a device group.

catena port-group

Creates a port group.

catena vlan-group

Creates a VLAN group.

interface

Assigns an interface to a configured port group.