H Commands
This chapter describes the Cisco NX-OS PIM commands that begin with H.
hardware profile multicast max-limit
To set the maximum number of entries in the multicast routing table, use the hardware profile multicast max-limit command.
hardware profile multicast max-limit max-entries
Syntax Description
max-entries |
Maximum number of entries in the multicast routing table. The range is from 0 to 16000. |
Command Default
None
Command Modes
Global configuration mode
Command History
|
|
6.0(2)N1(1) |
This command was introduced. |
Examples
This example shows how to set the maximum number of entries in the multicast routing table to 3000:
switch(config)# hardware profile multicast max-limit 3000
Warning!!: The multicast and /32 unicast route limits have been changed.
Any route exceeding the limit may get dropped.
Related Commands
|
|
show hardware profile status |
Displays information about the multicast routing table limits. |