The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS commands that begin with D that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 6000 switch.
To specify a description for a Fabric Extender, use the description command. To revert to the default description, use the no form of this command.
description description
no description
None
Fabric extender configuration mode
|
|
6.0(2)N1(1) |
This command was introduced. |
This example shows how to specify a description for a Fabric Extender:
switch#
configure terminal
switch(config)#
fex 101
switch(config-fex)#
description Rack16_FEX101
This example shows how to revert to the default description for a Fabric Extender:
switch#
configure terminal
switch(config)#
fex 101
switch(config-fex)#
no description
|
|
---|---|
fex |
Creates a Fabric Extender and enters Fabric Extender configuration mode. |
show fex |
Displays all configured Fabric Extender chassis connected to the switch. |
To configure the bootup diagnostic level to trigger diagnostics when the device boots, use the diagnostic bootup level command. To remove the bootup diagnostic level configuration, use the no form of this command.
diagnostic bootup level {bypass | complete}
no diagnostic bootup level {bypass | complete}
bypass |
Specifies that all bootup tests are skipped. |
complete |
Specifies that all bootup diagnostics are performed. This is the default value. |
Complete
Global configuration mode
|
|
---|---|
6.0(2)N1(1) |
This command was introduced. |
This example shows how to configure the bootup diagnostics level to trigger the complete diagnostics:
switch(config)# diagnostic bootup level complete
switch(config)#
This example shows how to remove the bootup diagnostics level configuration:
switch(config)# no diagnostic bootup level complete
switch(config)#
|
|
---|---|
show diagnostic bootup level |
Displays the bootup diagnostics level. |
show diagnostic bootup result |
Displays the results of the diagnostics tests. |