The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Policy Based Routing (PBR) commands that begin with R.
To enable policy-based statistics for a route map, use the route-map pbr statistics command. To disable statistics, use the no form of this command.
no route-map name pbr-statistics
Name of the route map. The name can be any alphanumeric string up to 63 characters. |
|
|
---|---|
Use the route-map pbr-statistics command to enable policy-based routing statistics. You must enable policy-based routing with the feature pbr command before you can enable policy-based routing statistics.
Note This command might fail if the same interface is configured for some other policy such as ACLs.
This example shows how to enable the policy based routing statistics for a route map:
|
|
---|---|
Identifies a route map to use the policy routing on an interface. |