Cisco Nexus 5600 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Preface
- A Commands
- B Commands
- C Commands
- E Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- N Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands
- A Commands
- C Commands
- D Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- A Commands
- C Commands
- D Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands

Find Matches in This Book

Results

Updated:: July 1, 2015

Chapter: H Commands

hardware profile ucast6 max-limit

H Commands

This chapter describes the Cisco NX-OS unicast Routing Information Base (RIB) and the Forwarding Information Base (FIB) commands that begin with H.

hardware profile ucast6 max-limit

To set the maximum number of unicast IPv6 entry limit for the host table, use the hardware profile ucast6 max-limit command.

hardware profile ucast6 max-limit max-limit

Syntax Description

max-limit

Maximum limit for the unicast IPv6 entries. The range is from 0 to 8000.

Defaults

4000

Command Modes

Global configuration mode

Command History

Release	Modification
6.0(2)N1(1)	This command was introduced.

Usage Guidelines

Use the hardware profile ucast6 max-limit command to limit the maximum number of host entries in the host table.

After setting the limit for multicast and IPv6 in the host table, the remaining number of entries are allocated for IPv4 host entries.

Note A limit set by using the hardware profile multicast max-limit command overrides the limit set by using the hardware profile ucast6 max-limit command.

This example shows how to set the maximum number of unicast IPv6 entry limit in the host table:

switch# configure terminal

switch(config)# hardware profile ucast6 max-limit 2500

Warning!!: The host (v4 & v6) unicast route limits have been changed.

switch(config)#

Related Commands

Command	Description
hardware profile multicast max-limit	Sets the maximum number of entries in the multicast routing table.
show hardware profile status	Displays information about the multicast and unicast routing table limits.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)