L Commands
This chapter describes the Cisco NX-OS Enhanced Interior Gateway Routing Protocol (EIGRP) commands that begin with L.
log-adjacency-changes (EIGRP)
To enable the logging of changes in the Enhanced Interior Gateway Routing Protocol (EIGRP) adjacency state, use the log-adjacency-changes command. To disable the logging of changes in the EIGRP adjacency state, use the no form of this command.
log-adjacency-changes
no log-adjacency-changes
Syntax Description
This command has no arguments or keywords.
Command Default
Adjacency changes are not logged.
Command Modes
Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History
|
|
|
|---|---|
5.0(3)N1(1) |
This command was introduced. |
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to enable logging of adjacency state changes for EIGRP 1:
switch(config)# router eigrp 1
switch(config-router)# address-family ipv4
switch(config-router-af)# log-adjacency-changes
switch(config-router-af)#
Related Commands
log-neighbor-warnings
To enable the logging of Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor warning messages, use the log-neighbor-warnings command. To disable the logging of EIGRP neighbor warning messages, use the no form of this command.
log-neighbor-warnings [seconds]
no log-neighbor-warnings [seconds]
Syntax Description
seconds |
(Optional) Time interval (in seconds) between repeated neighbor warning messages. The range of seconds is from 1 to 65535. |
Command Default
Neighbor warning messages are logged.
Command Modes
Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History
|
|
|
|---|---|
5.0(3)N1(1) |
This command was introduced. |
Usage Guidelines
Use the log-neighbor-warnings command to enable neighbor warning messages and to configure the interval between repeated neighbor warning messages.
This command requires the LAN Base Services license.
Examples
This example shows how to log neighbor warning messages for EIGRP process 209 and to repeat the warning messages in 5-minute (300 seconds) intervals:
switch(config)# router eigrp 209
switch(config-router)# log-neighbor-warnings 30
switch(config-router)#
Related Commands
|
|
|
|---|---|
log-adjacency-changes |
Enables logging of EIGRP adjacency state changes. |
show ip eigrp interfaces |
Displays information about EIGRP interfaces. |
Feedback