- About This Guide
- About the Firepower 7000 Series
- Hardware Specifications
- Installing a Firepower 7000 Series Managed Device
- Using the LCD Panel on a Firepower Device
- Deploying on a Management Network
- Deploying Firepower Managed Devices
- Power Requirements for Firepower 7000 Series Devices
- Using SFP Transceivers in Firepower 71x5 and AMP7150 Devices
Firepower 7000 Series Hardware Installation Guide
- Updated:
- July 12, 2018
Chapter: About the Firepower 7000 Series
About the Firepower 7000 Series
This chapter describes the Cisco Firepower 7000 Series devices, which are fault-tolerant, purpose-built network appliances available with a range of throughputs and capabilities.
Devices deployed on network segments within your organization monitor traffic for analysis. Devices deployed passively help you gain insight into your network traffic. Deployed inline, you can use Firepower devices to affect the flow of traffic based on multiple criteria.
You must manage Firepower 7000 Series devices with a Firepower Management Center.
Warning
Only trained and qualified personnel should install, replace, or service this equipment. Statement 49
Firepower 7000 Series Managed Devices Delivered with the Firepower System
The following table lists the managed devices that Cisco delivers with the Firepower System.
|
|
|
|
|---|---|---|
7000 Series Device Chassis Designations
The following table lists the chassis designations for the 7000 Series models available world-wide. The chassis code appears on the regulatory label on the outside of the chassis, and is the official reference code for hardware certifications and safety.
|
|
|
|---|---|
Feedback