- Using Cisco IOS XE Software
- Console Port Telnet and SSH Handling
- Configuring the Route Switch Processor
- Configuring Clocking and Timing
- G.8275.1 Telecom Profile
- Configuring the Global Navigation Satellite System
- Configuring Ethernet Interfaces
- Using the Management Ethernet Interface
- Configuring T1/E1 Interfaces
- Configuring Optical Interface Modules
- Configuring Serial Interfaces
- Enabling Support for Tunable DWDM-XFP-C
- Dying Gasp Support for Loss of Power Supply via SNMP, Syslog and Ethernet OAM
- Configuring Pseudowire
- Digital Optical Monitoring for Transceivers
- Configuring Synchronous Ethernet ESMC and SSM
- Configuring the SDM Template
- Tracing and Trace Management
- Configuring and Monitoring Alarm
- OTN Wrapper Overview
- Configuring 1G Traffic on 8-port 10 Gigabit Ethernet Interface Module
- Configuring Access Circuit Redundancy
- Index
Digital Optical Monitoring for Transceivers
Starting with release Cisco IOS XE Release 3.13, Digital Optical Monitoring (DOM) is supported for the SFP, SFP+, and XFP transceiver modules.
DOM is supported for ASR 900 RSP3 Module.
For information on DOM supported transceivers, see https://supportforums.cisco.com/document/75181/digital-optical-monitoring-dom.
For a list of modules, see Cisco ASR 903 Series Aggregation Services Router Hardware Installation Guide.
Real time DOM data is collected from SFPs, SFP+, and XFPs periodically and compared with warning and alarm threshold table values.
The DOM data collected are transceiver transmit bias current, transceiver transmit power, transceiver receive power, and transceiver power supply voltage.
The syslog messages are displayed when alarm threshold values are crossed.
 Note |
The transceiver parameters are not monitored when the port is in ADMIN-DOWN. |
Feedback