Configuring Ethernet OAM
This module describes the configuration of Ethernet Operations, Administration, and Maintenance (OAM) on the Cisco ASR 9000 Series Aggregation Services Routers.
Feature History for Configuring Ethernet OAM
Release |
Modification |
Release 3.7.2 |
Support for the following features was introduced:
|
Release 3.7.3 |
Support for the CFM Exploratory Linktrace feature was introduced. |
Release 3.9.0 |
Support for the Ethernet SLA feature was introduced. |
Release 3.9.1 |
Support for the following features was introduced:
|
Release 4.0.0 |
Support for the following features was introduced:
|
Release 4.0.1 |
Support for Ethernet CFM on Multi-Chassis Link Aggregation Groups (MC-LAG) was added. |
Release 4.1.0 |
Support for the following feature was introduced:
|
Release 4.2.0 |
Support for Unidirectional Link Detection Protocol (UDLD) was introduced. |
Release 4.3.0 |
Support for ITU-T Y.1731 Synthetic Loss Measurement was introduced. |
Release 4.3.1 |
Support for ITU-T Y.1731 Loss Measurement was introduced. |
Release 5.1.0 |
Support for Ethernet Data Plane Loopback was introduced. |
Release 5.1.2 |
Support for Ethernet CFM down MEP was included. |
Release 5.3.2 |
CFM support on the Bundle over Bundle is limited as follows: CFM software offload is not supported on the satellite access bundles (sub) interface over bundle ICL. If CFM is configured on any satellite access bundle interface over bundle ICL, bundle-offload configuration can not be applied. If CFM is configured only on interface in ASR 9000 series other than satellite access bundle interface over bundle ICL, then bundle-offload configuration can be applied. |