Initial Prime Network Services Controller Configuration
After installing Prime Network Services Controller, perform the following tasks to configure Prime Network Services Controller for use.
Task | Description |
---|---|
1. Configure Prime Network Services Controller connectivity with the hypervisor VM Manager. |
Required only if you did not perform this task as part of the post-installation activities. |
2. Verify service VM registration. |
Confirms that service VMs that were deployed directly on the hypervisor are registered with Prime Network Services Controller. |
3. Create user roles. |
Configures user roles and privileges. |
4. Configure authentication. |
Configures LDAP providers and identifies a primary authentication service. |
5. Create a trusted point. |
Configures trusted points for LDAP over SSL. |
6. Configure default system profiles and policies. |
Configures the default Prime Network Services Controller system profile. |
For more information on these tasks, see the Cisco Prime Network Services Controller User Guide or the online help.