The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
There are two steps to deploying configuration or monitoring templates:
1. Chose the template you want to deploy.
2. Specify the scope. After you have chosen the template to deploy, you need to determine which devices should be included in the deployment.
After you publish a template and want to deploy it to one or many devices, you can specify devices, values, and scheduling information to tailor your deployment. Table 13-1 explains the deployment options.
To deploy the DMVPN template, follow these steps.
Note You must publish the specified template before it can be deployed to devices.
Step 1 Choose Deploy > Configuration Tasks > My Templates.
Step 2 On the My Templates page, select the DMVPN template, and click the Tasked View button.
Step 3 From the Deploy Task pad, click Deploy.
The Template Deployment page opens.
Step 4 From the device selection section, select the list of devices on which to deploy the template.
Step 5 In the Value Assignment section, click the radio button to select the device.
Step 6 For DMVPN, you can change the values for GRE IP Address, Subnet Mask, and Tunnel Throughput Delay.
Step 7 If you have changed the values, click Apply.
Note The spoke option for Cisco IOS Software version 15.1(2)T or later should display the NHS cluster configuration section.
Step 8 In the Schedule section, enter the Job Name, then click one of the following radio buttons:
•Run—To run the job immediately.
•Run at Schedule Time—To specify a time to run the job.
Step 9 Under Summary, verify your entries, then click OK.
This task enables you to deploy the GETVPN group member and key server template.
Note Before you can deploy your template to devices, you must publish the template.
To deploy the GETVPN template:
Step 1 Choose Deploy > Configuration Tasks > My Templates.
Step 2 On the My Templates page, select the GETVPN-GroupMember or KeyServer template, and click the Tasked View button.
Step 3 From the Deploy Task Pad, click Deploy.
The Template Deployment page opens.
Step 4 From the Device Selection section, select the device and the location.
Step 5 In the Value Assignment section, click the radio button to select the device.
Step 6 For GETVPN-GroupMember, you can change the values for Registration Interface, Enable Passive SA, Local Exception Policy ACL, and Fail Close ACL.
Step 7 For GETVPN Key Server, you can change the values for Keyserver, WAN IP Address, ACL, Priority, and Cooperative servers.
Step 8 If you have changed the values, click Apply.
Step 9 Click the Schedule section, enter the Job Name, then click one of the following radio buttons:
•Run—To run the job immediately.
•Run at Schedule Time—To specify a time to run the job.
Step 10 Under Summary, verify your entries, then click OK.
The most common reasons that a template might not be deployed are:
•One or more devices are unreachable—Verify that the device credentials are correct; ping the device to verify that it is reachable. (See Using 360° View for more information.)
•A device CLI returned an error because the CLI was incorrect—Verify that the CLI commands contained in the template are correct by running the commands on a test device.