IP Tunneling

Document ID: 12276

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configure
      Network Diagram
      Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides sample configurations for Serial Tunneling (STUN) Complex Multipoint.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Configure

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.

Network Diagram

This document uses this network setup:

Configurations

This document uses these configurations:

stun peer-name 1.0.0.1 
stun protocol-group 9 sdlc 
stun protocol-group 13 sdlc 
interface serial 0 
encapsulation stun 
stun group 9 
stun route address c1 tcp 5.0.0.1 

interface serial 1 
encapsulation stun 
stun group 13 
stun route address c1 tcp 7.0.0.1 

interface loopback 0 
ip address 1.0.0.1 255.255.255.0 

stun peer-name 5.0.0.1 
stun protocol-group 9 sdlc 
interface serial 0 
encapsulation stun 
stun group 9 
stun route address c1 tcp 1.0.0.1 

interface loopback 0 
ip address 5.0.0.1 255.255.255.0 

stun peer-name 7.0.0.1 
stun protocol-group 13 sdlc 
interface serial 1 
encapsulation stun 
stun group 13 
stun route address c1 tcp 1.0.0.1 

interface loopback 0 
ip address 7.0.0.1 255.255.255.0 

Note: WAN configurations and IP routing configurations are not shown (for simplicity). Also, serial interfaces require clocking by the DCE device. Encoding (NRZ/NRZI ) on STUN Interfaces must match end device encoding - router defaults to NRZ.

Verify

There is currently no verification procedure available for this configuration.

The Output Interpreter Tool ( registered customers only) (OIT) supports certain show commands. Use the OIT to view an analysis of show command output.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

NetPro Discussion Forums - Featured Conversations

Related Information

• STUN/BSTUN Support Page
• Product Support
• Technology Support
• Technical Support & Documentation - Cisco Systems