Table 13-1 Command Summary
Command
|
Purpose
|
Router(config-subif)bert errors [number]
|
Transmits BERT errors while running any bert pattern.
|
Router(config-subif)bert pattern {0s | 1s | 2^15 | 2^20 | 2^23 | alt-0-1 | qrss} interval minutes}
|
Starts a BERT pattern on a port.
|
Router(config-subif)card type {t1 | e1} slot subslot
|
Configures ports on SPA in T1 or E1 mode.
|
Router(config-subif)card type {t3 | e3} slot subslot
|
Configures ports on SPA in T3 or E3 mode.
|
Router(config-subif)framing {sf | esf}
|
Selects the frame type for a T1 or E1 data line.
|
Router(config-subif)framing {c-bit | m23}
|
Selects the frame type for a T3 port.
|
Router(config-subif)framing {bypass | c-bit | m13}
|
Selects the frame type for a T3 or E3 port.
|
Router(config-subif)loopback {dte | local | network {line | payload} | remote}
|
Sets a loopback at various points in a transmitting and receiving path
|
Router(config-subif)mdl [string {eic | fic | generator | lic | pfi | port | unit}string] | [transmit {idle-signal | path | test-signal}]
|
Configures the Maintenance Data Link (MDL) message defined in the ANSI T1.107a-1990 specification
|
Router(config-subif)show controllers serial [slot/port]
|
Displays serial controller statistics.
|
Router(config-subif)show interfaces serial [number[:channel-group]] [accounting]
|
Displays information about a serial interface.
|
Router(config-subif)t1 channel framing {esf | sf}
|
Specifies the type of framing used by T1 channels.
|
Router(config-subif)ttb {country | rnode | serial | snode | soperator | x} line
|
Sends a trace trail buffer in E3 g832 framing mode.
|
