Table Of Contents

Cisco EnergyWise and Catalyst 6500 Switches

Cisco EnergyWise and Catalyst 6500 Switches

---

For Catalyst 6500 switches running EnergyWise Phase 2 and later:

•For high availability

–To perform an ISSU downgrade from a Cisco IOS release supporting EnergyWise Phase 2 and later to an earlier software release that does not support EnergyWise, first disable EnergyWise on the switch.

–To perform an ISSU downgrade from a Cisco IOS release supporting EnergyWise Phase 2 and later to an earlier release that does not support EnergyWise, remove the snmp-server enable traps energywise global configuration command from the switch configuration.

•For stateful switchover (SSO) mode

–On a redundant chassis operating in SSO mode, the energywise neighbor hostname udp-port-number global configuration command does not work. Use the energywise neighbor ip-address udp-port-number global configuration command to specify the IP address of the host.

For more information, see the "CLI Compatibility" section.