Table Of Contents
Specifications
This appendix provides system, port, and cabling specifications for the Cisco Secure Router 520 Series routers. It contains the following sections:
Router Specifications
Table A-1 provides the system specifications for the routers.
Table A-1 Router Specifications
Dimensions (W x D x H)
•
With antenna connectors: 10.578 in. (268.68 mm) x 8.65 in. (219.72 mm) x 1.719 in. (43.66 mm)
•
Weight (not including desktop power supply)
3.7 lb
Nonoperating temperature
-4 to 149°F (-20 to 65°C)
Nonoperating humidity
5 to 95% relative humidity
Nonoperating altitude
0 to 15,000 ft (4570 m)
Operating temperature
32 to 104°F (0 to 40°C)
Operating humidity
10 to 85% relative humidity
Operating altitude
0 to 10,000 ft (3000 m)
AC input voltage
100 to 240 VAC
Frequency
50 to 60 Hz
Power output
26 W maximum
Output voltages
5 V and 12 V
Radio technology
IEEE 802.11b and 802.11g standard compliant
Operating frequency
2412 to 2484 MHz ISM1 band
Modulation schemes
Number of channels
11 channels for the U.S., 13 channels for Europe, 14 channels for Japan
Data rate
54 Mbps with fallback rates of 48, 36, 24, 18, 12, 9, and 6 Mbps
Media access protocol
Power consumption (typical)
500 mA 3.3V at transmit mode, 320 mA/3.3V at receive mode
1 ISM = Industrial, Scientific, and Medical.
2 OFDM = orthogonal frequency-division multiplexing.
3 DQPSK = differential quaternary phase shift keying.
4 DBPSK = differential binary phase shift keying.
5 QAM = quadrature amplitude modulation.
6 CCK = complementary code keying.
7 CSMA/CA = carrier sense multiple access with collision avoidance.
8 ACK = acknowledgement.
LAN Port Pinouts
Table A-2 provides pinouts for the Ethernet LAN port on the routers.
Table A-2 Ethernet LAN Port Pinouts
1
RX+
2
RX-
3
TX+
4
Unused
5
Unused
6
TX-
7
Unused
8
Unused
Console Connector Pinouts
Table A-3 provides pinouts for the console connector (for connecting a terminal or PC).
Table A-3 Console Connector Pinouts (RJ-45-to-DB-9)
1
RTS
8
2
DTR
6
3
TXD
2
4
GND
5
5
GND
5
6
RXD
3
7
DSR
4
8
CTS
7
The console port is configured as a data communications equipment (DCE) device. The default parameters for the console port are as follows:
•
•
•
•
ADSL Port Connector Pinouts
Table A-4 provides the ADSL connector pinouts.
Cable Specifications
This section provides specifications for the following Ethernet cables, which you might need to provide:
•
•
Because of the autocrossover (autosensing) function, both straight-through and crossover cables can be used for the Ethernet LAN port.
Ethernet Cable Specifications
Table A-5 provides specifications that apply to both straight-through and crossover Ethernet cables.
Table A-5 Ethernet Cable Specifications
10BASE-T
Category 3 or 5
100BASE-T
Category 5 or higher
Maximum Cable Length
The maximum length for the Ethernet cables that connect the equipment to the router is 328 ft (100 m). This length is also the maximum distance between the router and the equipment connected to it.