Table Of Contents

Unsupported Commands

Unsupported Commands

---

Following is a list of the commands that are not supported in IOS release 12.0(9)SL for the Cisco 10000 series router:

Unsupported Frame Relay Commands

•FRF.12 fragmentation commands

•FRF.11 VoFR commands

•frame-relay adaptive-shaping {becn | foresight}

•frame-relay bc {in | out} bits

•frame-relay be {in | out} bits

•frame-relay cir {in | out} bps

•frame-relay custom-queue-list list-number

•frame-relay de-group group-number dlci

•frame-relay ip [rtp | tcp] header-compression [passive]

•frame-relay map protocol protocol-address dlci [broadcast] [ietf | cisco] [payload-compress {packet-by-packet | frf9 stac [hardware-options]}]

•frame-relay map ip ip-address dlci [broadcast] [cisco | ietf] [nocompress] tcp header-compression {active | passive}

•frame-relay mincir {in | out} bps

•frame-relay traffic-rate average [peak]

•frame-relay traffic-shaping

•show frame-relay ip [rtp | tcp] header-compression [interface]

Unsupported PPP Commands

•compress [predictor | stac | mppc [ignore-pfc]]

•debug ppp cbcp

•ppp bridge appletalk

•ppp bridge ip

•ppp bridge ipx [novell-ether | arpa | sap | snap]

•ppp reliable-link

Unsupported MLPPP Commands

•multilink load-threshold

•multilink max-fragments

•ppp multilink fragment-delay

•ppp multilink fragmentation

•ppp multilink idle-link

•ppp multilink interleave