Table Of Contents

Lawful Intercept Commands on Cisco IOS XR Software

lawful-intercept disable

Lawful Intercept Commands on Cisco IOS XR Software

---

This module describes the Cisco IOS XR software commands used to configure lawful intercept (LI).

For detailed information about keychain management concepts, configuration tasks, and examples, see the Implementing Lawful Intercept on Cisco IOS XR Software configuration module.

lawful-intercept disable

To disable the lawful intercept feature, use the lawful-intercept disable command in global configuration mode. To reenable the lawful intercept feature, use the no form of this command.

lawful-intercept disable

no lawful-intercept disable

Syntax Description

This command has no arguments or keywords.

Defaults

Lawful intercept feature is enabled by default.

Command Modes

Global configuration

Command History

Release	Modification
Release 3.7.0	This command was supported on the Cisco XR 12000 Series Router.
Release 3.8.0	This command was supported on the Cisco CRS-1.

Usage Guidelines

To use this command, your Cisco IOS XR software system administrator must assign you to a user group associated with a task group that includes the corresponding command task IDs. If you need assistance with your task group assignment, contact your system administrator. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of Cisco IOS XR System Security Configuration Guide.

You should not disable lawful intercept when there is an active TAP in progress or the TAP will be deleted.

Task ID

Task ID	Operations
li	read, write

Examples

The following example shows the use of the lawful-intercept disable command:

RP/0/RP0/CPU0:router(config)# lawful-intercept disable