Table 7-1 Command Summary
Command
|
Purpose
|
Router(config-if)# card slot 4jacket-1
|
Preprovisions a line card slot in the Cisco 10000 series router to accept a Cisco 10000 SIP-600.
|
Router# debug hw-module subslot
|
To debug a SPA and all of its interfaces.
|
Router(config-if)# end
|
Prompts you to save the configuration changes and exits the configuration session.
|
Router(config-if)# hold-queue length in
|
Configures the input hold queue in units of packets.
|
Router(config)# interface gigabitethernet
slot/subslot/port
|
Specifies the Gigabit Ethernet interface to configure.
|
Router(config-if)# ipv4 address ip-address mask
or
Router(config-if)# ipv6 address
ipv6-prefix/prefix-length
|
Sets a primary or secondary IP address for an interface.
|
Router(config-if)# ip accounting mac-address
[input | output]
|
Generates accounting information for IP traffic based on the source and destination MAC addresses on LAN interfaces.
|
Router(config-if)# mac-address ieee-address
|
Modifies the default MAC address of an interface to a user-defined address.
|
Router(config-if)# mtu value
|
Sets the maximum transmission unit (MTU) value for the interface.
|
Router(config-if)# negotiation auto
|
Enables advertisement of speed, duplex mode, and flow control on a Gigabit Ethernet interface.
|
Router(config-if)# no shutdown
|
Enables an interface.
|
Router(config-if)# plim qos input map
|
Classifies ingress packets into priority and nonpriority queues on Gigabit Ethernet SPAs.
|
Router# show controllers interface
slot/subslot/port [detail]
|
Displays initialization block information, transmit ring, receive ring, transmission statistics and errors, and applicable MAC destination address and VLAN filtering tables for Gigabit Ethernet SPA interface controllers.
|
Router# show hw-module subslot [all | slot/subslot]
[fpd | oir | sensors | transceiver port-number]
|
Displays diagnostic information about internal hardware devices for all SPAs or a specific SPA.
|
Router# show interfaces
|
Displays the configured interface and checks the status of each interface port.
|
Router# show running-config
|
Displays the router's running configuration and interfaces available in the system.
|
Router# show version
|
Displays the current software version, and can also be used to confirm that the router recognizes the line card.
|
