How do I register a Cisco TelePresence MCU / IP VCR / IP GW with a V2IU Gatekeeper?
To register a Cisco TelePresence MCU, IP VCR or IP Gateway with a V2IU gatekeeper, follow these steps:
- On the V2IU:
- Go to VoIP ALG > H.323 and set the Gatekeeper mode to Embedded gatekeeper mode.
- Go to H.323 prefixes and add any prefixes and the address of the unit they should be routed to.
- On the MCU/IP VCR/IP GW go to Settings > Gatekeeper and:
- Set H.323 gatekeeper usage to Enabled.
- For H.323 gatekeeper address enter the address of your V2IU.
- For Gatekeeper registration type select Terminal / Gateway (if you are not registering prefixes) or Gateway (if you are registering prefixes).
- Leave Prefix for MCU registrations, Prefix for IP VCR registrations or Prefix for IP GW registrations blank.
- For H.323 ID to register enter the identifier for your unit.
- For MCU service prefix enter the prefix for your unit, if any.
- Click Apply changes to register your unit with the V2IU.
This article applies to the following products:
- Cisco TelePresence IP GW 3500 / MSE IPGW blade
- Cisco TelePresence IP VCR 2200 / MSE VCR blade
- Cisco TelePresence MCU 4200 / MSE 8420
- Cisco TelePresence MCU 4500
- Cisco TelePresence MSE 8510 blade
April 13th, 2011 |
TAA_KB_52 |