Cisco Wireless Controller Configuration Guide, Release 8.8

FlexConnect AP Easy Admin

The FlexConnect AP Easy Admin enables unified AP GUI access and configure the following parameters to connect to the controller:

AP IP address: Static or DHCP IP address.
Controller IP address priming: Ablity to configure the primary, secondary, and tertiary controller, and their IP addresses.
CAPWAP preferred DNS configuration.
PPPoE: Enabling of FlexConnect submode and configuring the username and password for PPPoE server authentication.
TFTP: AP image upgrade through TFTP.

Step 1

Choose Wireless > Access Points > Global Configuration.

The Global Configuration page is displayed.

Step 2

In the AP Easy Configuration section, check the Enable Global AP Easy Configuration check box.

Note

Easy Configuration is only applicable to the following Cisco Wave 1 (IOS-based) APs: 702, 1530, 1700, 2700, and 3700.

Step 3

Click Apply.

Step 1

Enable or disable AP Easy Admin on the controller by entering this command:

config network ap-easyadmin {enable| disable}

Step 2

View the network summary and to verify the status of AP easy admin feature by entering this command:

show network summary