The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS FabricPath commands that begin with H.
To configure the hop limit for fabricpath OAM service packets in the Transparent Interconnection of Lots of Links (TRILL) protocol header, use the hop command in fabricpath OAM profile configuration mode. To revert the hop limit to the default value, use the no form of the command.
hop val
no hop
val |
Hop limit. The range is from 1 to 255. Default is 64. |
The hop limit for fabricpath OAM service packtes is 64 hops.
Fabricpath oam profile (config-fp-oam-profile)
|
|
---|---|
7.0(0)N1(1) |
This command was introduced. |
Use the hop count specified in the FabricPath OAM packet header to determine the hop limit to address issues caused by infinite loops.
This example shows how to configure a FabricPath OAM service packet hop limit of 25:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath oam profile 100
switch(config-fp-oam-profile)# hop 25
|
|
---|---|
To configure a dynamic hostname exchange for Intermediate-System-to-Intermediate System (IS-IS), use the hostname dynamic command. To return to the default setting, use the no form of this command.
hostname dynamic
no hostname dynamic
This command has no arguments or keywords.
ON
FabricPath IS-IS configuration mode
|
|
---|---|
5.2(1)N1(1) |
This command was introduced. |
This command requires an Enhanced Layer 2 license.
This example shows how to configure a dynamic hostname exchange for IS-IS:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# hostname dynamic
switch(config-fabricpath-isis)#
|
|
---|---|
show hostname |
Displays the system's hostname. |