The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS FabricPath commands that begin with E.
To configure the fabricpath Operation, Administration, and Maintenance (OAM) flow profile ether type (payload of an Ethernet Frame), use the ether-type command in fabricpath OAM flow profile configuration mode. To remove the ether-type, use the no form of this command.
ether-type ether-type
no ether-type
ether-type |
The flow profile ether-type. The range is from 0x0 to 0xffff. |
Flow profile ether-type is not configured.
Fabricpath oam profile flow (config-fp-oam-profile-flow)
|
|
---|---|
7.0(0)N1(1) |
This command was introduced. |
Ether-type is the payload of an Ethernet Frame. In the FabricPath OAM packet header, the ether type comes after VLAN.
This example shows how to configure a description for a fabricpath OAM profile:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath oam profile 100
switch(config-fp-oam-profile)# flow forward
switch(config-fp-oam-profile-flow)# ether-type 0x0
|
|
---|---|