Have an account?
Need an account?
Cisco IWAN Application on APIC-EM User Guide, Releases 1.6.0, 1.6.1
New and Changed Information
View with Adobe Reader on a variety of devices
This chapter contains the following section:
The following table summarizes new and changed features in the Cisco IWAN app, releases 1.6.0 and 1.6.1.
Table 1-1 New and Changed Features, IWAN App Releases 1.6.0, 1.6.1
Port range / IP subnet based custom app
Ability to specify a port range or an IP subnet when defining a new NBAR2 custom application.
Adding a New Application
NAT IP / Custom port enhancement
Ability to specify custom NAT port, and to modify NAT IP and port settings after provisioning (Day N).
Configuring System Settings
Delete service provider address pools
Ability to delete IP address pools when they are not used on any hub or spoke router.
Configuring IP Address Pools
Deleting Address Pools
MC selection on branch sites
Ability to select master controller (MC) device during provisioning (Day 0) of a branch site with two routers.
Adding and Provisioning Greenfield Devices to the Branch Site
Adding and Provisioning Brownfield Devices to the Branch Site
Support for Cisco ISR 1100 Series and Cisco ISR 4221 routers
Support added for Cisco ISR 1100 Series routers and the Cisco ISR 4221 router at branch sites. See the release notes for details.
Cisco IWAN Application on APIC-EM Release Notes, Release 1.6.0
Cisco IWAN Application on APIC-EM Release Notes, Release 1.6.1