hw-module cts-enable all
To enable the Cisco TrustSec (CTS) for all ASR 9000 Enhanced Ethernet Line Cards use the hw-module cts-enable all command in global configuration mode.
hw-module cts-enable all
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
Global configuration
Command History
Release | Modification |
---|---|
Release 5.2.0 |
This command was introduced. |
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator for assistance.
The CTS solution allows you to intelligently control access to corporate data, allowing access control policies to be applied uniformly anywhere in the network. Use the hw-module cts-enable all command to manually enable an interface on the device for CTS, so that the device can propagate the CTS packet throughout the network.
Task ID
Task ID | Operation |
---|---|
root-lr |
read, write |
Examples
The following example shows how to enable CTS.
RP/0/0RP0RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:IMC0(config)#hw-module cts-enable all