RST Commands
This chapter provides restore (RST) commands for the Cisco ONS 15454, ONS 15327, ONS 15310-CL, ONS 15310-MA, and ONS 15600.
20.1 RST-<MOD2>
(Cisco ONS 15454, ONS 15327, ONS 15310-CL, ONS 15310-MA, ONS 15600) The Restore 10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS1, DV6000, E1, E3, E4, EC1, ESCON, ETRCLO, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, OC12, OC192, OC3, OC48, OCH, OMS, OTS, POS, STS1, STS12C, STS18C, STS192C, STS24C, STS36C, STS3C, STS48C, STS6C, STS9C, T1, T3, VC12, VC3, VT1, or VT2 (RST-<MOD2>) command provisions a facility in service.
Usage Guidelines
See Table 27-1 for supported modifiers by platform.
Note This command can only be executed when the port is in the Out of Service and Maintenance (OOS,MT) state.
Category
Ports
Security
Maintenance
Input Format
RST-<MOD2>:[<TID>]:<AID>:<CTAG>::::[<PST>[,<SST>]];
Input Example
RST-EC1:CISCO:FAC-1-1:1::::IS,AINS;
Input Parameters
<AID> |
Access identifier from the "ALL" section. |
<PST> |
Primary state. Defaults to IS. The parameter type is PST, which indicates the current overall service condition of an entity. |
•IS |
In service |
•OOS |
Out of service |
<SST> |
Secondary state. Defaults to AINS. The parameter type is SST, which provides additional information pertaining to PST and PSTQ. |
•AINS |
Automatic In-Service |
•DSBLD |
Disabled |
•LPBK |
Loopback |
•MEA |
Mismatch of Equipment |
•MT |
Maintenance |
•OOG |
Out of Group |
•SWDL |
Software Download |
•UAS |
Unassigned |
•UEQ |
Unequipped |
20.2 RST-EQPT
(Cisco ONS 15454, ONS 15327, ONS 15310-CL, ONS 15310-MA, ONS 15600) The Restore Equipment (RST-EQPT) command provisions equipment into the In Service (IS) state from the Maintenance (MT) state.
Usage Guidelines
This command is only applicable to equipment that is in transition from the MT state to the IS state.
Category
Equipment
Security
Maintenance
Input Format
RST-EQPT:[<TID>]:<AID>:<CTAG>[::];
Input Example
RST-EQPT:CISCO:SLOT-1:1;
Input Parameters