AVC Supported Platforms and Interfaces

This chapter addresses the following topics:

AVC Supported Platforms

Cisco AVC is supported on the following platforms:

  • Cisco IOS Platforms (Cisco ISR G2 Routers)

– Cisco C1921-AX/K9

– Cisco C1941-AX/K9

– Cisco C2901-AX/K9

– Cisco C2911-AX/K9

– Cisco C2921-AX/K9

– Cisco C2951-AX/K9

– Cisco C3925-AX/K9

– Cisco C3925E-AX/K9

– Cisco C3945-AX/K9

– Cisco C3945E-AX/K9

– Cisco 800 Series: C892FSP-K9, C896VA-K9, C897VA-K9, C897VAW-A-K9, C897VA-M-K9, C898EA-K9, C897VAW-E-K9, C897VAM-W-E-K9.

  • Cisco IOS XE Platforms

– Cisco ASR1000 Series Aggregation Services Routers

– Cisco ISR4400 Series Integrated Services Routers

– Cisco CSR 1000V Cloud Services Routers

For information about licensing and features for supported platforms, see:
AVC Licensed Features

Logical Interface and VPN Support in AVC

Unsupported Logical Interfaces

Logical interfaces not supported by Cisco AVC in the current release:

  • Dialer interfaces

Supported on Cisco IOS platforms, not supported on Cisco IOS XE platforms

  • Multiprotocol Label Switching (MPLS)
  • Overlay Transport Virtualization (OTV) overlay interfaces
  • IPv6 tunnels that terminate on the device

Also see Pass-through Tunneled IPv6 Traffic: Classification and Reporting.

Partially Supported Logical Interfaces

Logical interfaces partially supported by Cisco AVC in the current release:

  • Virtual template interface

Only ezPM monitors can be configured on the virtual template. Static performance monitors (non-ezPM monitors) cannot be configured on the virtual template.

VPN Support

AVC support for VPN modes in the current release:

  • FLEXVPN

Supports spoke-to-spoke and hub-to-spoke topologies.

FLEXVPN does not support IPv6.

Only ezPM monitors can be configured for FLEXVPN. Static performance monitors (non-ezPM monitors) cannot be configured for FLEXVPN.

  • EzVPN

Only ezPM monitors can be configured for ezVPN. Static performance monitors (non-ezPM monitors) cannot be configured for EzVPN.