Installing the Cisco GS7000 Node
For more information, see the Cisco 1.2 GHz GS7000 Remote PHY Module Compatible 2X2 Segmentable Node Installation and Configuration Guide.
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
For more information, see the Cisco 1.2 GHz GS7000 Remote PHY Module Compatible 2X2 Segmentable Node Installation and Configuration Guide.
For more information, see the Cisco 1.2 GHz GS7000 Remote PHY Module Compatible 2X2 Segmentable Node Installation and Configuration Guide.
Step 1 |
Open the Cisco GS7000 node; remove all the transmitter and receiver modules (if any). |
Step 2 |
Remove the fiber handler containing the 4 SC-SC adapters from the R-PHY packing material, and snap into the R-PHY top cover. |
Step 3 |
Insert the location pin on the OIB of the Cisco GS7000 node into the location hole on the Cisco RPD. Tighten the screws on the Cisco RPD with recommended torque. |
Step 1 |
Change the Forward Control Switch in launch amp to Rphy option. |
||||||||||||||||||||||||||||||||||
Step 2 |
Change the Reverse Control Switch to 4x1 or 4x2 based on your network. |
||||||||||||||||||||||||||||||||||
Step 3 |
Place the ≥6dB pad at forward path and 0dB pad at reverse path on the OIB.
|
||||||||||||||||||||||||||||||||||
Step 4 |
For Reverse Path (4x2 mode):
Configuration Definition
|
For more information, see the Cisco 1.2 GHz GS7000 Remote PHY Module Compatible 2X2 Segmentable Node Installation and Configuration Guide.
For more information, see the Cisco 1.2 GHz GS7000 Remote PHY Module Compatible 2X2 Segmentable Node Installation and Configuration Guide.