Green – 2 Hz

Power-On initializing

Indicates good power.

Green – 4 Hz

IP acquired by DHCP, synchronizing and acquiring configuration.

Indicates that remote SSHv2 session is possible.

Green – Steady

System status good – Connection is good.

No faults are detected.

Red – 2 Hz

Connection Fault – No physical connection to CIN or RF Interfaces.

Red – 4 Hz

Configuration fault - Failed synchronization or failed to receive configuration from the CCAP core.

Wrong DHCP configuration, unreachable hosts, failed authentication.

Red – Steady

System Fault – Device cannot initialize.

Hardware fault.

Amber – various

Warning – RPD operational but imperfect.

Vendor defined LED behavior.

Green – Flash

Per IEEE 802.3x.

Indicates connection state

Unilluminated

Ethernet port failure or port disabled.

Indicates possible port failure or port which has been configured to be disabled.

Green – 2 Hz

Power-On downstream RF initializing.

At least one pilot and/or tone active.

Green – 4 Hz

Port or ports activated.

Awaiting downstream port set configuration.

Green – Steady

Downstream port set configuration obtained.

Downstream ports operational.

Unilluminated

RF port fault or muted.

Green – 2 Hz

At least one upstream port configuration received (and a MAP was received for that port), awaiting upstream burst transmissions.

Indicates that the RPD has received and applied at least one upstream port configuration.

Green – 4 Hz

First upstream transmission recognized.

Indicates that at least one CD’s burst transmission has been received.

Green – Steady

At least one CM has successfully completed upstream ranging.

Upstream deemed operational.

Unilluminated

Upstream RF port fault or no configuration.