RPD Reset

Finding Feature Information

Your software release may not support all the features that are documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. The Feature Information Table at the end of this document provides information about the documented features and lists the releases in which each feature is supported.

Hardware Compatibility Matrix for Cisco Remote PHY Device


Note

Unless otherwise specified, the hardware components introduced in a given Cisco Remote PHY Device Software Release are supported in all subsequent releases.
Table 1. Hardware Compatibility Matrix for the Cisco Remote PHY Device

Cisco HFC Platform

Remote PHY Device

Cisco GS7000 Super High Output Node

Cisco 1x2 / Compact Shelf RPD Software 2.1 and Later Releases

Cisco GS7000 Super High Output Intelligent Node (iNode)

Cisco 1x2 / Compact Shelf RPD Software 4.1 and Later Releases

Cisco Intelligent Remote PHY Device 1x2

  • PID—iRPD-1X2=

  • PID—iRPD-1X2-PKEY=


Note

The -PKEY suffix in the PID indicates units that enable the SCTE-55-2 Out-of-Band protocol support.

Information about RPD Reset

Starting from Cisco 1x2 / Compact Shelf RPD Software 6.1, factory reset and NVRAM reset via TLV and CLI are supported. In the factory reset, RPD restores the factory configuration and performs cold reboot. In this case, it is better for the RPD to have golden image, otherwise users need to boot the RPD manually. In the NVRAM reset, RPD clears the non-volatile configuration and performs cold reboot.

Resetting RPD


Note

To know more about the commands referenced in this module, see the Cisco IOS Master Command List.


To clear the configuration, image and logs of the RPD, perform factory reset as shown in the following example:

R-PHY#reboot factory-reset
Warning: This action will restore the factory configuration. Are you sure you want to do the factory reset (yes/no)?

To clear the non-volatile configuration of the RPD, perform NVRAM reset as shown in the following example:

R-PHY#reboot nv-reset
Warning: This action will clear the non-volatile configuration. Are you sure you want to do the nvreset (yes/no)?

SoftReset

SoftReset is supported from RPD V6.6 release. You can softReset RPD by RPD CLI or write TLV 40.1.1(RpdResetCtrl to softReset(1)).

To perform soft-reset by RPD CLI, use the reboot soft-reset command:

R-PHY# reboot soft-reset 
Warning: This action will perform a soft reset. Are you sure you want to do the soft reset (yes/no)?yes
SoftReset in 10 seconds

Feature Information for RPD Reset

Use Cisco Feature Navigator to find information about the platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to the www.cisco.com/go/cfn link. An account on the Cisco.com page is not required.


Note

The following table lists the software release in which a given feature is introduced. Unless noted otherwise, subsequent releases of that software release train also support that feature.


Table 2. Feature Information for RPD Reset

Feature Name

Releases

Feature Information

Factory reset support

Cisco 1x2 / Compact Shelf RPD Software 6.1

This feature was introduced on the Cisco Remote PHY Device.

Softreset support

Cisco 1x2 / Compact Shelf RPD Software 6.6

This feature was introduced on the Cisco Remote PHY Device.