Remote Management on SPA8000 Analog Telephone Adapter

Available Languages

Download Options

  • PDF     (26.6 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (67.3 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (152.9 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:December 11, 2018
Document ID:SMB2392

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Remote Management on SPA8000 Analog Telephone Adapter

Objective

Remote management allows you to manage the SPA8000 from a remote location via the Internet. With remote management, you can access the administration web server from a computer that is not directly connected to the SPA8000. The objective of this article is to explain how to configure remote management on the SPA8000 Analog Telephone Adapter.

Applicable Device

• SPA8000 Analog Telephone Adapter

Software Version

• 6.1.12

Configuration of Remote Management

Step 1. Log into the web configuration utility as an administrator or user and choose Advanced > Network > WAN Status. The WAN Status page opens:

Step 2. Scroll down to the Remote Management section.

Step 3. Choose yes from the Enable WAN Web Server drop down list to enable the WAN Web Server. This allows access to the administration web server from a computer which is not directly connected to the phone adapter. The default value is yes.

Step 4. Enter the WAN web server port in the WAN Web Server Port field. The WAN Web Server Port is used for WAN access to the ATA device. The default value is 80.

Step 5. Click Submit All Changes to save the settings.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products