Configuration of Native VLAN on the SF and SG 200/300 Series Managed Switches

Available Languages

Download Options

  • PDF     (119.9 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (192.9 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (131.3 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:December 11, 2018
Document ID:SMB3090

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuration of Native VLAN on the SF and SG 200/300 Series Managed Switches

Objective

Virtual LAN (VLAN) allows a group of hosts that are not connected to the same switch to communicate as if they were on the same broadcast domain. An interface that has VLAN traffic needs to have the VLANs assigned to that interface, or packets may be dropped. When GARP VLAN registration protocol (GVRP) is enabled for an interface, then VLANs can be dynamically assigned and it is not necessary to manually assign them.

This document explains how to configure Native VLAN on the 200/300 switch series.

Applicable Devices

• 200 Series Switches
• 300 Series Switches

Native VLAN Configuration

Step 1. In the web configuration utility, choose VLAN Management > Default VLAN Settings. The Default VLAN Settings page opens:

Step 2. In the Default VLAN ID After Reboot field enter the VLAN which is your Native VLAN ID number.

Step 3. In the web configuration utility, choose Administration > Management Interface > IPv4 Interface. The IPv4 Interface page opens:

Step 4. Choose the VLAN you want to be the Management/Native VLAN in the Management VLAN drop-down list.

Step 5. Assign an IP address to the management VLAN in the IP Address field.

Step 6. Click Apply to save settings.

Revision History

Revision Publish Date Comments
1.0
11-Dec-2018
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco