The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The factory default reset erases all configuration settings that have been modified by the user, and restores the device to its original settings. This may be helpful if you lose the password to a device and wish to regain access. Performing a reboot restarts the device with a saved configuration.
The objective of this document is to show you how to reset to factory default settings and how to reboot the RV130 and RV130W.
The router can be reset to the factory default settings through either the web configuration utility or the reset button on the back of the router.
Step 1. Log in to the web configuration utility and choose Administration > Restore Factory Defaults. The Restore Factory Defaults page opens:
Step 2. To reset the device, click the Default button. This will erase all current configurations.
Step 3. A confirmation window appears. Click Yes to continue.
Step 4. After the reboot is completed, login with the default credentials. The default username is cisco and the default password is cisco.
Step 1. Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing.
The Router reloads and is set to the default configuration settings.
Step 2. Login with the default credentials. The default username is cisco and the default password is cisco.
The router can be reset to the factory default settings through either the web configuration utility or the power button on the back of the router.
Step 1. Log in to the web configuration utility and choose Administration > Reboot. The Reboot page opens:
Step 2. Click the Reboot button to reboot the device.
Step 3. After the reboot is completed, login with the saved administration credentials.
Step 1. Press the power button to turn off your device. After 15 seconds have passed, press the power button a second time to power the device back on.
Step 2. After the reboot is completed, login with the saved administration credentials.