PIX 6.x: مرور نفق IPsec عبر جدار حماية PIX باستخدام قائمة الوصول ومثال التكوين NAT

Current configuration:
 !
 version 12.4
 service timestamps debug uptime
 service timestamps log uptime
 no service password-encryption
 !
 hostname goss-2621
 !
 ip subnet-zero
 !
 ip audit notify log
 ip audit po max-events 100
 isdn voice-call-failure 0
 cns event-service server
 !
 
!--- IKE Policy

 crypto isakmp policy 10
  hash md5
  authentication pre-share
 crypto isakmp key cisco123 address 10.99.99.2     
 !
 crypto ipsec transform-set myset esp-des esp-md5-hmac 
 !
 crypto map mymap local-address FastEthernet0/1
 
!--- IPSec Policy

 crypto map mymap 10 ipsec-isakmp   
  set peer 10.99.99.2
  set transform-set myset
 
!--- Include the private-network-to-private-network traffic !--- in the encryption process.

  match address 101
 !
 controller T1 1/0
 !
 interface FastEthernet0/0
  ip address 10.2.2.1 255.255.255.0
  no ip directed-broadcast
  duplex auto
  speed auto
 !
 interface FastEthernet0/1
  ip address 10.1.1.2 255.255.255.0
  no ip directed-broadcast
  duplex auto
  speed auto
 
!--- Apply to interface.

  crypto map mymap
 !
 ip classless
 ip route 0.0.0.0 0.0.0.0 10.1.1.1
 no ip http server
 
!--- Include the private-network-to-private-network traffic !--- in the encryption process.

 access-list 101 permit ip 10.2.2.0 0.0.0.255 10.3.3.0 0.0.0.255
 line con 0
  transport input none
 line aux 0
 line vty 0 4
 !
 no scheduler allocate
 end

fixup protocol dns maximum-length 512
fixup protocol ftp 21
fixup protocol h323 h225 1720
fixup protocol h323 ras 1718-1719
fixup protocol http 80
fixup protocol rsh 514
fixup protocol rtsp 554
fixup protocol sip 5060
fixup protocol sip udp 5060
fixup protocol skinny 2000
fixup protocol smtp 25
fixup protocol sqlnet 1521
fixup protocol tftp 69

!--- The fixup protocol esp-ike command is disabled by default.

fixup protocol esp-ike

ip address outside 10.99.99.1 255.255.255.0
 ip address inside 10.1.1.1 255.255.255.0
 
!--- Range of registered IP addresses for use.

 global (outside) 1 10.99.99.50-10.99.99.60
 
!--- Translate any internal source address when !--- going out to the Internet.

 nat (inside) 1 0.0.0.0 0.0.0.0 0 0
 static (inside,outside) 10.99.99.12 10.1.1.2 netmask 255.255.255.255 0 0

 
!--- or

 access-list acl-out permit esp host 10.99.99.2 host 10.99.99.12
 access-list acl-out permit udp host 10.99.99.2 host 10.99.99.12 eq isakmp
 access-list acl-out permit udp host 10.99.99.2 host 10.99.99.12 eq 4500

!--- It is important to permit UDP port 4500 for NAT-T because the PIX is acting !--- as a NAT device between the routers.

 access-group acl-out in interface outside
 
 isakmp enable outside
 isakmp enable inside
 Command configured in order to enable NAT-T
isakmp nat-traversal 20
 route outside 0.0.0.0 0.0.0.0 99.99.99.2 1
 route inside 10.2.2.0 255.255.255.0 10.1.1.2 1

version 12.4
 service timestamps debug uptime
 service timestamps log uptime
 no service password-encryption
 !
 hostname goss-3660
 !
 ip subnet-zero
 !
 cns event-service server
 !
 
!--- IKE Policy

 crypto isakmp policy 10
  hash md5
  authentication pre-share
 crypto isakmp key cisco123 address 10.99.99.12    
 !
 crypto ipsec transform-set myset esp-des esp-md5-hmac 
 !
 crypto map mymap local-address FastEthernet0/0
 
!--- IPSec Policy

 crypto map mymap 10 ipsec-isakmp   
  set peer 10.99.99.12
  set transform-set myset
 
!--- Include the private-network-to-private-network traffic !--- in the encryption process.

  match address 101
 !
 interface FastEthernet0/0
  ip address 10.99.99.2 255.255.255.0
  no ip directed-broadcast
  ip nat outside
  duplex auto
  speed auto
 
!--- Apply to interface.

  crypto map mymap
 !
 interface FastEthernet0/1
  ip address 10.3.3.1 255.255.255.0
  no ip directed-broadcast
  ip nat inside
  duplex auto
  speed auto
 !
 interface Ethernet3/0
  no ip address
  no ip directed-broadcast
  shutdown
 !
 interface Serial3/0
  no ip address
  no ip directed-broadcast
  no ip mroute-cache
  shutdown
 !
 interface Ethernet3/1
  no ip address
  no ip directed-broadcast
 interface Ethernet4/0
  no ip address
  no ip directed-broadcast
  shutdown
 !
 interface TokenRing4/0
  no ip address
  no ip directed-broadcast
  shutdown
  ring-speed 16
 !
 
!--- Pool from which inside hosts translate to !--- the globally unique 10.99.99.0/24 network.

 ip nat pool OUTSIDE 10.99.99.70 10.99.99.80 netmask 255.255.255.0
 
!--- Except the private network from the NAT process.

 ip nat inside source route-map nonat pool OUTSIDE
 ip classless
 ip route 0.0.0.0 0.0.0.0 10.99.99.1
 no ip http server
 !
 
!--- Include the private-network-to-private-network traffic !--- in the encryption process.

 access-list 101 permit ip 10.3.3.0 0.0.0.255 10.2.2.0 0.0.0.255
 access-list 101 deny   ip 10.3.3.0 0.0.0.255 any
 
!--- Except the private network from the NAT process.

 access-list 110 deny   ip 10.3.3.0 0.0.0.255 10.2.2.0 0.0.0.255
 access-list 110 permit ip 10.3.3.0 0.0.0.255 any
 route-map nonat permit 10
  match ip address 110
 !
 line con 0
  transport input none
 line aux 0
 line vty 0 4
 !
 end