Guest

IP Multicast

Multicast Catalyst Switches Support Matrix

Document ID: 29480



Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
CGMP and IGMP Snooping Catalyst Switches Support Matrix
CGMP Feature Catalyst Switches Support Matrix
IGMP Snooping Feature Catalyst Switch Support Matrix
GMRP and RGMP Catalyst Switches Support Matrix
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides information on the support of Layer 2 multicast features in various Cisco Catalyst Series Switches.

These tables provide more information:

Refer to the IP Multicast support page for additional information on implementing the multicast feature and for sample configurations and troubleshooting tips.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to the Cisco Technical Tips Conventions for more information on document conventions.

CGMP and IGMP Snooping Catalyst Switches Support Matrix

This table provides information related to Cisco Group Management Protocol (CGMP) and Interior Gateway Management Protocol (IGMP) snooping feature support in Cisco Catalyst Switches.

Catalyst Platform

CGMP (Minimum Software Version)

Default

IGMP Snooping (Minimum Software Version)

Default

IGMP V3 (Minimum Software Version)

Catalyst 6000 - Catalyst OS (CatOS) Software

Not supported(1)

N/A

Yes (all versions)

Enabled (since 5.5.9 and 6.3.1)

Yes (7.5) (2)

Catalyst 6000- Cisco IOSĀ® Software

Not supported(1)

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(8a)E)

Catalyst 5000

Yes (2.2)

Disabled

Yes (4.1)(3)

Disabled

Not supported

Catalyst 4000 - CatOS (Supervisor Engine 1/2) / (2948G/4912G/2980G)

Yes (2.2)

Disabled

Not supported

N/A

Not supported

Catalyst 4000 - Cisco IOS (Supervisor Engine 2+/3/4/5)

Not supported(1)

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EW)

Catalyst 3550

Not supported(1)

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 3560

Not Supported

N/A

Yes (Cisco IOS Software Release 12.1(19)EA1)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 3750

Not supported(1)

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 2940

Not supported(1)

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 2950/2955

Not supported

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 2960

Not supported

N/A

Yes (all versions)

Enabled

Yes (all versions)

Catalyst 2970

Not supported

N/A

Yes (all versions)

Enabled

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 2900XL/3500XL

Yes (all versions)

Enabled

Not supported

N/A

Not supported

Catalyst 2948G-L3 / 4908G-L3

Yes (supports CMF in all versions)(4)

N/A

Not supported

N/A

Not supported

Catalyst 1900/2820

Yes (5.33)

Disabled

Not supported

N/A

Not supported

Catalyst 8500

Yes (supports CMF in all versions)(4)

Disabled

Not supported

N/A

Not supported

  • (1) The CGMP server feature is supported in Multilayer Switch Feature Card (MSFC), MSFC2, Catalyst 4000 Supervisor Engine III/IV and Catalyst 3550 and 3750 switches. The CGMP Layer 2 feature is not supported.

  • (2) On Catalyst 6500s, before software release 6.3(10), an IGMP Version 3 (V3) packet with more than one group in the same packet was discarded. This is rectified in software release 6.3(10). Software releases 6.3(x) run IGMP Version 2 (V2), and there is no support for V3. An IGMP V3 report is treated as a set of IGMP V2 reports for each of the multicast groups forming the group records in IGMP V3. This happens regardless of the filter mode of the IGMP V3 report. Refer to Cisco bug ID CSCdw61628 ( registered customers only) for more information. IGMP V3 is supported beginning with version 7.5 software (only in Supervisor Engine II-based Catalyst 6500 systems), and Cisco IOS Software Release 12.1(11b)E1 or later is required on the MSFC2.

  • (3) For Catalyst 5000s, Supervisor Engine II G or III G, or Supervisor Engine III with a NetFlow Feature Card (NFFC) or NFFC II, is required for IGMP snooping support. Supervisor Engine software release 4.1 or later is required. Certain hardware requires a later version of software. (For example, the NFFC II requires software release 4.3 or later.)

  • (4) Constrained Multicast Flooding (CMF) is a Cisco IOS Software method of performing IGMP snooping. It was created for Cisco IOS Layer 3 switches.

CGMP Feature Catalyst Switches Support Matrix

This table lists the CGMP feature support and the commands to enable the feature.

Catalyst Platform

CGMP

CGMP leave

Fastleave

Catalyst 5000

set cgmp {enable | disable}

set cgmp leave {enable | disable}

Not supported

Catalyst 4000 - CatOS (Supervisor Engine 1/2) / (2948G/4912G/2980G)

set cgmp {enable | disable}

set cgmp leave {enable | disable}

set cgmp fastleave {enable | disable}

Catalyst 2900XL/3500XL

[no] cgmp

[no] cgmp leave processing

Not supported

Catalyst 2948G-L3 / 4908G-L3

[no] bridge cmf

Not supported

Not supported

Catalyst 1900/2820

[no] cgmp

[no] cgmp leave processing

Not supported

Catalyst 8500

[no] bridge cmf

Not supported

Not supported

IGMP Snooping Feature Catalyst Switch Support Matrix

This table lists IGMP snooping, IGMP querier, IGMP Filtering, IGMP Throttling, and IGMP Multicast VLAN Registration feature support and the commands needed in order to enable the feature.

Catalyst Platform

IGMP Snooping

IGMP Fastleave

IGMP Filtering (Minimum Software Version)

IGMP Querier (Minimum Software Version)

IGMP Throttling (Minimum Software Version)

Multicast VLAN Registration (Minimum Software Version)

Catalyst 6000 - CatOS Software

set igmp {enable | disable}

set igmp fastleave {enable | disable}

Not supported

set igmp querier {disable | enable} vlan_id

7.1

Not supported

Not supported

Catalyst 6000- Cisco IOS Software

[no] ip igmp snooping

[no] ip igmp snooping fastleave

Not supported

[no] ip igmp snooping querier

(under VLAN interface)

(Cisco IOS Software Release 12.1(8a)E)

Not supported

Not supported

Catalyst 5000

set igmp {enable | disable}

set igmp fastleave {enable | disable}

Not supported

Not supported

Not supported

Not supported

Catalyst 4000 - Cisco IOS Software (Supervisor Engine 2+/3/4)

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(11b)EW)

Currently not supported

Not supported

Not supported

Catalyst 3550

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(8)EA1)

Currently not supported

Yes (Cisco IOS Software Release 12.1(19)EA1

Yes (Cisco IOS Software Release 12.1(8)EA1

Catalyst 3560

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(19)EA1)

Yes (Cisco IOS Software Release 12.2(25)SEA)

Yes (Cisco IOS Software Release 12.1(19)EA1)

Yes (Cisco IOS Software Release 12.1(19)EA1)

Catalyst 3750

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(11)AX)

Yes (Cisco IOS Software Release 12.2(25)SEA

Yes (Cisco IOS Software Release 12.1(19)EA1

Yes (Cisco IOS Software Release 12.1(11)AX

Catalyst 2940

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(11)AX)

Currently not supported

Yes (Cisco IOS Software Release 12.1(19)EA1

Yes (Cisco IOS Software Release 12.1(13)AY

Catalyst 2950/2955

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(9)EA1)

2950:

Not supported

2955:

Yes (Cisco IOS Software Release 12.1(22)EA4

Yes (Cisco IOS Software Release 12.1(19)EA1

2950:

Yes (Cisco IOS Software Release 12.1(6)EA2c

2955:

Yes (Cisco IOS Software Release 12.1(12c)EA1

Catalyst 2960

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.2(25)FX

Yes (Cisco IOS Software Release 12.2(25)FX

Yes (Cisco IOS Software Release 12.2(25)FX

Yes (Cisco IOS Software Release 12.2(25)FX

Catalyst 2970

[no] ip igmp snooping

[no] ip igmp snooping vlan_id immediate-leave

Yes (Cisco IOS Software Release 12.1(11)AX)

Yes (Cisco IOS Software Release 12.2(25)SEA

Yes (Cisco IOS Software Release 12.1(19)EA1

Yes (Cisco IOS Software Release 12.1(11)AX

Additional Notes

  1. IGMPv3 join and leave messages are not supported on switches that run IGMP Filtering or Multicast VLAN Registration.

  2. Switches support IGMPv3 snooping based only on the destination multicast MAC address and does not support snooping based on the source MAC address or on the proxy reports.

GMRP and RGMP Catalyst Switches Support Matrix

This table lists support for Generic Attribute Registration Protocol (GARP) Multicast Registration Protocol (GMRP) and Router-Port Group Management Protocol (RGMP) support on Catalyst Switches.

Catalyst Platform

GMRP (Minimum Software Version)

RGMP (Minimum Software Version)

Catalyst 6000 - CatOS Software

Yes (5.2)

Yes (5.4)

Catalyst 6000 - Cisco IOS Software

Not supported

Yes (Cisco IOS Software Release 12.1E)

Catalyst 5000

Yes (1) (5.1)

Yes (5.4)

Catalyst 4000 - CatOS (Supervisor Engine 1/2) / (2948G/4912G/2980G)

Yes (5.1)

Not supported

Catalyst 4000 - Cisco IOS Software (Supervisor Engine 2+/3/4)

Not supported

Not supported

Catalyst 3550

Not supported

Not supported

Catalyst 3750

Not supported

Not supported

Catalyst 2940

Not supported

Not supported

Catalyst 2950/2955

Not supported

Not supported

Catalyst 2970

Not supported

Not supported

Catalyst 2900XL/3500XL

Not supported

Not supported

Catalyst 2948G-L3 /4908G-L3

Not supported

Not supported

Catalyst 1900/2820

Not supported

Not supported

Catalyst 8500

Not supported

Not supported

  • (1) Catalyst 5000 requires Supervisor Engine II, IIG, III, or IIIG for GMRP support.

Additional Notes

  • You cannot enable GMRP if IGMP snooping is enabled.

  • RGMP requires that IGMP snooping is enabled on the switch.

  • Both GMRP and RGMP are disabled by default on all supported switches.

NetPro Discussion Forums - Featured Conversations

Networking Professionals Connection is a forum for networking professionals to share questions, suggestions, and information about networking solutions, products, and technologies. The featured links are some of the most recent conversations available in this technology.
NetPro Discussion Forums - Featured Conversations for LAN
Network Infrastructure: LAN Routing and Switching
Network Infrastructure: Getting Started with LANs

Related Information



Updated: Jul 17, 2006Document ID: 29480