Downloads |
Document ID: 14164
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Flowchart
NetPro Discussion Forums - Featured Conversations
Related Information
Introduction
This document shows the E1 PRI troubleshooting flowchart.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Flowchart
In order to view more infomation, click the command boxes. Click the infomation in red to go to the next flow chart.
NetPro Discussion Forums - Featured Conversations
| NetPro Discussion Forums - Featured Conversations for Access |
| Network Infrastructure: Remote Access |
Related Information
- E1 Troubleshooting
- E1 Layer 1 Troubleshooting
- E1 Alarm Troubleshooting
- E1 Error Event Troubleshooting
- Hard Plug Loopback Test for E1 Lines
- Technical Support & Documentation - Cisco Systems
| Updated: Nov 14, 2005 | Document ID: 14164 |