You can use regular expressions in the ip as-path access-list command with Border Gateway Protocol (BGP). This document describes scenarios for using regular expressions. For more general information about regular expressions, see the Cisco Documentation on Regular Expressions.
Readers of this document should be knowledgeable of the following:
The information in this document is based on the software and hardware versions:
Cisco IOS® Software Release 12.0
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, see the Cisco Technical Tips Conventions.
The following network diagram is referred to in these three scenarios.
If you would like for Router 1 to receive only the routes originated from AS 4 (and no Internet routes), you can apply an inbound access list on Router 1 as follows:
ip as-path access-list 1 permit ^4$ router bgp 1 neighbor 220.127.116.11 remote-as 4 neighbor 18.104.22.168 route-map foo in route-map foo permit 10 match as-path 1
This ensures only networks originated from AS 4 are allowed into Router 1.
If you want only the networks that have passed through AS 4 to enter AS 3 from Router 3, you can apply an inbound filter on Router 3.
ip as-path access-list 1 permit _4_ router bgp 3 neighbor 22.214.171.124 remote-as 1 neighbor 126.96.36.199 route-map foo in route-map foo permit 10 match as-path 1
You can use an underscore (_) as the input string and output string in the ip as-path access-list command. Note that in this example anchoring (for instance, there is no ^) is not used, so it does not matter what autonomous systems come before and after AS 4.
If you want to deny all the networks that have originated in AS 4 and permit all other routes to enter AS 3 from Router 3, you can apply an inbound filter at Router 3, as follows:
ip as-path access-list 1 deny _4$ ip as-path access-list 1 permit .* router bgp 3 neighbor 188.8.131.52 remote-as 1 neighbor 184.108.40.206 route-map foo in route-map foo permit 10 match as-path 1
If you want AS 1 to get networks originated from AS 4 and all directly attached ASs of AS 4, apply the following inbound filter on Router 1.
ip as-path access-list 1 permit ^4_[0-9]*$ router bgp 1 neighbor 220.127.116.11 remote-as 4 neighbor 18.104.22.168 route-map foo in route-map foo permit 10 match as-path 1
In the ip as-path access-list command, the carat (^) starts the input string and designates "AS". The underscore (_) means there is a a null string in the string that follows "AS 4". The [0-9]* specifies that any connected AS with a valid AS number can pass the filter. The advantage of using the [0-9]* syntax is that it gives you the flexibility to add any number of ASs without modifying this command string. For additional information, see AS-Regular Expression.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.