Document ID: 82061
Introduction
This series of interactive documents uses a typical head office and branch
office in order to demonstrate some common voice network configurations. This
interactive diagram allows you to view network configurations:
|
|||||||||||||||||||||||||||||||||||||
This image is interactive!Click a component to view configuration and troubleshooting information. |
|||||||||||||||||||||||||||||||||||||
Refer to Unified CallManager Interactive Voice Network Configuration and Troubleshooting Case Study for requirements assumed by this series of interactive documents.
Configure
In order to configure an MGCP gateway in Unified CallManager for the RTP location, complete these steps:
- In Cisco CallManager, click Device > Gateway > Add a New Gateway.
- Select the type of gateway from the Gateway type drop-down list.
- Choose MGCP from the Device Protocol drop-down list.
- Select the hardware modules in your gateway, and click Insert.
- Enter a domain name, description, and CallManager group in the appropriate
fields.
Note: Make sure your domain name matches the host name on the Cisco MGCP gateway. Refer to MGCP IOS Gateway (RTP) Interactive Voice Network Configuration Example for more information.
- Click (1/0) in order to configure the T1 interface, and choose T1
PRI.
- Choose the appropriate values for your network. Use the diagram in the
Introduction section in order to locate more information
about each configuration option.
- Once the gateway is created, click the Reset Gateway button in order
to reset the gateway.
| Updated: Apr 16, 2007 | Document ID: 82061 |