This document provides details for the necessary modifications when changing the IP address of the Cisco Secure (CS) AAA server.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
There are five places where you need to make modifications if you change the address of the Cisco Secure AAA server.
Note: BASEDIR = Directory where CiscoSecure is installed.
Complete these steps:
Change the IP_Addr value to the new IP address.
Change the value for the "STRING config_server_ip_address" parameter to the new IP address.
Change the value for the address parameter to the new IP address.
Perform a search and replace to replace the old IP address with the new IP addresses on these two files. These files are not used in production, but you can change them for completeness.
It is also recommended that you have hostname resolution completely configured using either hosts files or DNS. Configuring the hostname resolution ensures that all machines can resolve each other's names to the new IP address.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.