Cisco Unified Intelligent Contact Management Enterprise

Document ID: 20442

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Installation
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document explains how to install the Nortel Symposium software on a Cisco Peripheral Gateway (PG) in order to activate the Peripheral Interface Manager (PIM). Follow these instructions after you have installed the Cisco Intelligent Contact Management (ICM) software on the PG.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

• Cisco ICM

• Microsoft Windows Registry

Components Used

The information in this document is based on these software and hardware versions:

• Cisco ICM version 4.6.2 only

• Nortel Symposium SCCS Release 1.5

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Note: These instructions are for Symposium Call Center Release 1.5 only.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Installation

Complete these steps:

1. Create this directory on the PG: C:\Nortel\Client\EN\Bin .

2. Copy these two files into the new directory from the Nortel CD:

   • Nbnmsrvc.exe

   • NICOMS

3. In the Control Panel, double-click Open System.

4. In the System Environment Variables, select Path.

5. Add C:\Nortel\Client\EN\Bin to the string in the Value box.

6. Click Set.

7. Click OK.

8. From the Start menu, click Run.

9. Type regedit, and click OK to open the registry.

10. Add the HKEY_LOCAL_MACHINE\Software\Nortel\Setup\NINAMESERVER entry.

11. Create the subkeys listed in this table:

    Secondary Key	Type	Value
    Mode	REG_DWORD	0
    CLan	REG_SZ	IP Address of PG
    DefaultCardName	REG_DWORD	0
    NSAddr	REG_SZ	IP Address of PG
    SiteName	REG_SZ	PG Hostname
    NSPath	REG_SZ	C:\Nortel\Client\EN\Bin\nbnmsrvc.exe
    ErrorCode	REG_DWORD	1
    ErrorMessage	REG_SZ	Installing Name Service

12. From the command prompt in the new directory, run NICOMS_1.exe.

    Check the Error Code and Error Message in the registry. They must return a value of 0 and OKAY!! respectively to indicate a successful setup.

13. Start ICM Services to make the PIM Active.

NetPro Discussion Forums - Featured Conversations

Related Information

• Technical Support & Documentation - Cisco Systems