Document ID: 108893
Updated: Dec 12, 2008
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. Which type of cable can I use to connect to RPS1000?A.
The connector cable for RPS1000 is the RPSCBL1. This type cable is proprietary to Linksys. This is a 4-foot, 14-pin to 16-pin connector cable that enables connection of the RPS1000 redundant power supply to an external device. This allows the PSU to supply power to the connected device in the event that its power supply fails. The RPS1000 only comes with one RPSCBL1. Additional cables can be purchased thru Linksys.
Linksys RPSCBL1 Cable
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.