This document is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
A. There are few steps you can try in order to isolate problems regarding random reboots on your SPA962 phones:
Replace the switch
If possible, you may try replacing the switch where the SPA9XX phones are connected. You may also want to check the physical connections of your SPA9XX to it by inspecting the cables and LED light.
You may temporarily disable provisioning on your SPA9XX to check if that is causing the reboot.
Check your SPA962 IP Address. You can obtain the IP address through the LCD screen on the IP phone. Press the Setup Button, then press 9. The LCD screen displays the current IP address.
Launch your browser, type http://IP_Address_of_your_SPA962 in the address field, and then click Enter.
You are now ready to configure the SPA962. If the web interface is asking for a username and password, this means that the unit was locked by your Provider. Please contact your respective VoIP Provider for assistance.
Go to Admin Login > Advanced, click the Provisioning tab, and then set Provision Enable to no.
Click Submit All Changes.
Debug your SPA and configure Syslog
The SPA9XX sends out debug information via syslog to a syslog server. It is recommended to capture SIP packets on your SPA9XX in order to determine the reason for the reboot. By default, it uses port 514.
Access your SPA9XX web user interface. Perform the instruction mentioned above.
Go to Admin, then Advanced. Click on the System tab, set Debug Server to the IP address of your syslog server (i.e. x.y.z.w:PORT). This IP address must be reachable from the SPA device. Set the Debug Level to 3. Click Submit All Changes.
In order to capture SIP signaling messages, under the line tab, set SIP Debug Option to full. File output will be "syslog.514.log". Click Submit All Changes.
Note: Make sure that your PC's firewall will not block port 514.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.