Document ID: 108801
Updated: Dec 12, 2008
Contents
Introduction
How do I reset the IP phone to factory default?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How do I reset the IP phone to the factory default?
A.Rebooting the SPA941
In order to reset the SPA941 to the factory default, complete these steps:
Step 1:
Press the Setupon the SPA941.
Step 2:
Using Navigationselect Factory Reset (12).
Step 3:
Press OK soft key afterwards.Step 4:
SPA will reboot and will be back to its default settings.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.
Updated: Dec 12, 2008
Document ID: 108801