What can I do if the contact list/user status returns UNAVAILABLE message?
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. What can I do if the contact list/user status returns UNAVAILABLE message?A.
Getting an UNAVAILABLE message when trying to retrieve the Contact list on the phone is caused by not properly starting or logging into the SKYPE software installed in the PC, the USB driver or the USB plug is disconnected, and the PC may be in hibernate mode. To resolve this, follow the instructions below.
Check if the base station is connected to your PC's USB port and the PC is not in hibernate mode.
Start the SKYPE software and log into your SKYPE account.
Start the USB driver by double-clicking the Linksys Cordless Internet Telephony Kit icon located at the lower-right corner of your computer's screen if it is not already started.
Note: Once the USB driver is installed on your PC, the Telephony Kit should start automatically when you start the PC.
Once both the SKYPE and base station are active, the Telephony Kit is ready for use. Your current SKYPE online status should be shown on the handset's display screen.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.