This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
A. SPA products are SIP phone appliances that are VoIP endpoints in a SIP network. Cisco Small Business products comply with the SIP RFC 3261/2543 and work well with all SIP service providers. SPA products can be used in conjunction with a SIP proxy server or can be configured for IP calls. SPA products do a DHCP request by default and are compatible with all DHCP servers.
A. Currently, Cisco Small Business SPA products support the SIP protocol and work only in SIP environments.
A. Bandwidth usage depends on the audio codec that is used. For best voice quality and FAX, the audio codec must be G711, by default. These are the estimated bandwidth requirements for 1 channel usage:
G711—64Kbps (can be 90Kbps with overhead)
A. If a firewall is enabled, unblock UDP ports 5060, 5061 and the port range from 16384-16482. Disable SPI if the function is present in your firewall.
If the SIP server that registers the SPA product supports NAT, you can use the Outbound Proxy configuration of the SPA product in order to connect to it. Otherwise, the SPA product also supports STUN protocol. See the SIP tab configuration from the web GUI.
STUN does not work if you have a symmetric NAT. If you enable the debug through syslog, and set STUN test to yes, the SPA product prints the information about whether or not you have a symmetric NAT.
A. SPA products support up to three Ring Equivalence Numbers (REN). REN is a measurement of how much ringing power certain telephone equipment requires. REN numbers are used to determine how much telephone equipment you can connect to the same telephone line and still have them ring properly. A typical line can drive about a three REN load. If you connect multiple phones on line 1 of the SPA device, the total REN of the phones must not exceed three RENs. The same applies to line 2.
A. Hardware version numbers can differ on identical-looking SPA devices. This version number is for Cisco Small Business technical support identification purposes. The behavior of the two products is identical. However, it is best to stay current with the latest firmware release for your hardware version.
A. Cisco Small Business SPA products are shipped with universal power adapters with different prongs (US, ANZ, EU, or UK type prongs). Specify the type of power adapter you need when you place your order.
A. Automatic provisioning is included in the Cisco Small Business Provisioning Guide, available to authorized service providers.
A. There are several available, such as:
A. Complete these steps:
- Choose FWD > Vonage and dial **243 1 Area_Code vonage_number.
- Choose Vonage > FWD and dial 011 0 393 FWD_Number. Check with your service provider for more information.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.