This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How to enable the remote management feature of SPA9000?A.
To access the Web UI while the device is set to Bridge Mode, you will have to enable the WAN Web Server option with the default WAN Web Server Port set to 80. For instructions, complete these steps:
Enabling the Remote Management Feature
Access the SPA-9000 web-based setup page. For instructions, click here.
Select Router and then click on Wan Setup.
Look for Enable WAN Web Server under Remote Management and select yes, then enter port "80" as the WAN Web Server Port.
Click on Apply all changes.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.