This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How do I configure Night time Auto Attendant on SPA9000?A.
This article will show you how to configure the Night time Auto Attendant (AA) on SPA9000.
Configuring the Night Time AA on SPA9000
Access the SPA9000's web-based setup page. For instructions, click here.
When the web-based setup page appears, click Admin Login then advanced.
Click Voice then SIP.
Change Day Time to desired preferred time of the user where:
(hh for hours, mm for minutes, and ss for seconds)
Forexample,start=9:0:0;end=17:0:0 means the start time is 9 AM and the end time is 5 PM. The other hours (5 PM to 9 AM) are considered nighttime hours.
Click Line 1 then look for Contact list and enter "aa"
Change the Time Zone to GMT +08:00 (this is equal to Philippine time). IP phones will automatically reboot and obtain the same time zone.
Check the Current AA.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.