Document ID: 108807
Contents
Introduction
How can I reset my SPA9000 back to factory defaults?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. How can I reset my SPA9000 back to factory defaults?
A.Resetting the SPA9000 to Factory Default
By default, the SPA9000 should not ask for any username and password when you open its web interface. To reset the unit back to factory defaults follow the instruction below.
Step 1:
Using the analog phone connected to the SPA9000's FXS port, dial **** 73738# then press 1 to confirm the reset.
Note: If it still asks for a password then that means this unit is already provisioned by a certain provider. Whoever provisioned the device is the only one who can remove it. Unfortunately, there is no back door. http://www.linksys.com/support
Related Information
| Updated: Dec 12, 2008 | Document ID: 108807 |