What can I do if I'm experiencing choppy/one way audio when I call PSTN using the SPA400?
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. What can I do if I'm experiencing choppy/one way audio when I call PSTN using the SPA400?A.
Experiencing Choppy Line when Using SPA400
Access the SPA3102's web-based setup page. For instructions, click here.
When the SPA3102's web-based setup page appears, click Voice.
Under Preferred Coder, select G.711U.
Under Voice Coder, set all VAD to ON.
Perform a power cycle.
Note: It will also be helpful if you set the SPA400 on the WAN side of the SPA9000 and make sure that Proxy Network Interface is set to WAN. This can be found under the SIP tab of the SPA9000.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.